nicodim4/Arduino-Temperature-Control-Library: Arduino library for interfacing with Maxim temperature sensors

examples/SetUserData/SetUserData.ino

47 строк1 KB

per1234

Move example sketch to appropriately named folder

23 июл 2018, 10:43

23 июл 2018, 10:43f0eae5f

//
// This sketch does not use the ALARM registers and uses those 2 bytes as a counter
// these 2 bytes can be used for other purposes as well e.g. last temperature or
// a specific ID.
// 

#include <OneWire.h>
#include <DallasTemperature.h>

// Data wire is plugged into port 2 on the Arduino
#define ONE_WIRE_BUS 2

// Setup a oneWire instance to communicate with any OneWire devices (not just Maxim/Dallas temperature ICs)
OneWire oneWire(ONE_WIRE_BUS);

// Pass our oneWire reference to Dallas Temperature. 
DallasTemperature sensors(&oneWire);

int count = 0;

void setup(void)
{
  // start serial port
  Serial.begin(9600);
  Serial.println("Dallas Temperature IC Control Library Demo");

  // Start up the library
  sensors.begin();
  
}

void loop(void)
{ 
  // call sensors.requestTemperatures() to issue a global temperature 
  // request to all devices on the bus
  Serial.print("Requesting temperatures...");
  sensors.requestTemperatures(); // Send the command to get temperatures
  Serial.println("DONE");
  
  Serial.print("Temperature for the device 1 (index 0) is: ");
  Serial.println(sensors.getTempCByIndex(0));  
  
  count++;
  sensors.setUserDataByIndex(0, count);
  int x = sensors.getUserDataByIndex(0);
  Serial.println(count);
}